Showcase Cages and adhesive

Quote:

---

Originally Posted by Reinz

That looks great Justin! :) Much better than mine. Compared to your perfectly straight lines mine looks like a 4 year old did it.

---

Thank you Reinz! They are not that straight but not too noticeable on the ceiling.


Sent from my iPhone using Tapatalk

Update: the loctite powergrab doesn't work all that great. It started falling down in a few spots so I hit it with some hot glue. That is still holding well. I ordered another cage today, I'll try just hot glue this time.


Sent from my iPhone using Tapatalk

Sounds like Pit was on the money on that call. :)

I am surprised though since I have done 6 cages of 4 different makes. I haven't had any failures yet. And with my snakes going in and out of water bowls I had humidity spikes in the 90s.

New snake = new cage setup again. I ran out of hot glue sticks and found Gorilla glue sticks. My hi-temp glue gun is ten watts, found a 20 watt gun. This combo works 10x better than my old glue gun and el cheapo glue sticks. Found both at Walmart.

https://uploads.tapatalk-cdn.com/201...66f002739a.jpg


Sent from my iPhone using Tapatalk

If I recall correctly, Showcase Cages are made with HDPE and it's going to be hard to get anything to stick to that. HLH Reptiles put up a video series a while back were this problem came up. If you'd like, you can see the rundown on what was tried and what worked. Anyhow, if the gorilla glue doesn't work, you might try Locktite Plastics Bonding System.

Yes, not much sticks to polyethylene plastic. I couldn't find the loctite plastic bonding locally, but this hot glue works great and is much cheaper.


Sent from my iPhone using Tapatalk