Rack / Herpstat help!

I would try moving the probe to another location than the pre set location on a trial basis and monitor the temps from there. Make sure to only put tape over the probe wire and not the probe itself though. :)

Quote:

---

Originally Posted by Albert Clark

I would try moving the probe to another location than the pre set location on a trial basis and monitor the temps from there. Make sure to only put tape over the probe wire and not the probe itself though. :)

---

I'm sorry, what do you mean the probe wire only, and not the probe?

Thanks

The probe sensor is the end and larger part of the wire. You shouldn't be putting tape over the sensor part. Tape behind the sensor but make sure that the sensor is flush and less than one quarter inch away from your heat tape.

Quote:

---

Originally Posted by Stearns84

I'm sorry, what do you mean the probe wire only, and not the probe?

Thanks

---

My mistake, i meant to say sensor. Don't tape over the sensor. Sorry.

Can you show us a photo of your thermostat's probe location?

Thanks

Brian

I'll snap a few pictures tonight when I get off of work for you guys.

Thanks again for all your help with everything!