DIY Rack Advice

As long as you can cut the smaller stuff yourself, I would sure hope they can handle that.

The rack is coming along! I just have to secure the wires, tape down the heat tape, and put the back on.

I did run into a some issues with the cuts. For starters they ripped the sheet down the middle, which cut my back pieces in half. I specifically told them not to do that. Then they cut my side pieces different. One was 1/8th off and the other a 1/16th. They replaced the pieces they split in 2 but I didn't say anything about the side pieces. After I assembled it I planed the backs of the shelves to sit flush.

Thanks again!

http://tapatalk.imageshack.com/v2/15...ae9d6adf99.jpg

so you made them a cut sheet and they still had issues.... just wow. glad you made it work though.