Hides?

:gj: Which one you going with?

http://tapatalk.imageshack.com/v2/14...f51afb21e4.jpg

Its better than nothing but this one is only a few bucks more from a very trusted brand.

http://www.reptilebasics.com/ve-hobbystat

I have a zoomed rheostat now. I only have $35. And my heatmat is already attached to my tank. So one with a probe will be useless for me.

Quote:

---

Originally Posted by deathangel579

I have a zoomed rheostat now. I only have $35. And my heatmat is already attached to my tank. So one with a probe will be useless for me.

---

ALL tstats have a probe. You can mount the probe to the bottom if your set on not pulling it off a bit. Mount it just the same. I suggest aluminum foil tape. Remember to tape the wire behind the probe. Do not tape the probe bulb itself.

To clarify things. The probe reads temperature and reports it to the tstat which then varies the output of power to uth to give the desired temperature. Without a probe a tstat will not work.

This one says heat mat plugs into it and then this plugs into the wall. Maybe i read it wrong but i didnt see anything about a probe.

If i do what u said, with the tape, the wire wont melt?

Oops. I went up on the actual site. It has a probe. Sorry. Lol

Quote:

---

Originally Posted by deathangel579

This one says heat mat plugs into it and then this plugs into the wall. Maybe i read it wrong but i didnt see anything about a probe.

---

You plug the tstat into the wall and plug the uth into the tstat. You then run the probe where needed to monitor the heating devices temperature. You will understand better when you get it.

Quote:

---

Originally Posted by deathangel579

If i do what u said, with the tape, the wire wont melt?

---

If it does something is seriously wrong. Many here use foil tape because it works. We know from experience.

Ok so the wire should be ok touching the heat mat?