Help on putting Holes in tubs!

Quote:

---

Originally Posted by Slim

I use one of these...

http://www.rcplanet.com/Dynamite_Knu..._p/dyn3045.htm

Works like a dream and leaves very smooth symmetrical holes.

---

That looks sweet....

Sent from my ADR6350 using Tapatalk 2

soldiering iron here

I have met a breeder whom uses a soldering iron and it works perfectly!!! It looks good too, because of no sharp edges left over :D

Quote:

---

Originally Posted by Mike41793

Drill with a quarter inch bit. People say it will crack the tubs but ive never encountered that problem. Or you could melt them with a soldering iron. Drill/melt from the inside out so any sharp pieces stay on the outside of the tub.

---

Though, soldering irons are quicker, I drill holes and haven't cracked a tub yet.

I used a pair of scissors to put holes in a Tupperware container earlier today in order to transport my snake. It seemed to work just fine, but if I were to need to make a decent amount of holes (like setting up a few tubs), I would use a soldering iron.

Soldering iron works great. Its easy to use and you won't crack the tub which occasionally happens when using a drill.

The way to keep the plastic from cracking is to have something for your drill bit to drill into after it penetrates the thin plastic tub. That is more than likely when it cracks because we tend twist or tilt the bit when it makes it through. This lets it grabs the plastic and breaks it.. Try placing the plastic down on a piece of scrap wood (2x4 or something) this will help keep your bit straight because it boars right through the plastic and into the wood....

25 years experience in construction.... ZERO years in owning a Snake... Soon to be changed though !

my fav thing to use is a hot glue gun