Where to put thermostat probe in cage with rhp ?

Those probes with the herpstat2 are measuring temperatures only! The % numbers on the right of the thermostat is what percent of power is going to the heat pad since it is a proportional thermostat apposed to an on/off one....

http://www.spyderrobotics.com/store/...products_id=15

The herpstat 2 can be used to control RH too. I am not sure if the OP is using one or not I am a touch unclear on that point.

Sigh. I typed up a reply and the tapatalk crashed.

Anyways, it figures I don't have the right probes for humidity. Lol. I'll have to get those then. Thanks!

Once those come in, I'll need to take the entire top off the cage to attach this more properly but here's what I did tonight to get the probes as close to the rhp's as possible without using tape.

I used cable management doohickeys and hot glue gun glue to attach the probe to the panels.

http://img.tapatalk.com/6344b473-3192-8eb1.jpg

http://img.tapatalk.com/6344b473-31a1-84dc.jpg


Sent from my iPhone using Tapatalk

The globbing of the glue is due to the awkward position. I'll have to do this all over again and hopefully without the globbing.


Sent from my iPhone using Tapatalk

Make sure you remove the snake while blobbing the glue!!
http://images109.fotki.com/v786/phot...hpprobe-vi.jpgHosted on Fotki

Mine is no better!!