Do you even Vape bro? Vape/E-Cig Discussion

Just built some dual coils came out to .9 ohms...have it set to 20 watts right now, but not sure if that's the correct wattage

Quote:

---

Originally Posted by jclaiborne

Just built some dual coils came out to .9 ohms...have it set to 20 watts right now, but not sure if that's the correct wattage

---

Wattage is all preference with rebuildables as long as you dont go over the amp limits on your batteries. I vape at 30w on a .6ohm coil

Sent from my SPH-L720 using Tapatalk 2

Quote:

---

Originally Posted by bigt0006

Wattage is all preference with rebuildables as long as you dont go over the amp limits on your batteries. I vape at 30w on a .6ohm coil

Sent from my SPH-L720 using Tapatalk 2

---

With a VV mod doesn't it regulate it so you can go over the amp limits?

Quote:

---

Originally Posted by jclaiborne

With a VV mod doesn't it regulate it so you can go over the amp limits?

---

If its a built in battery yeah if it takes an 18650 or some other type of replaceable battery you still need to watch your amperage. The sigelei 150w recomends 2 vtc4 30 amp batteries and you can vape down to a .15 ohm build as long as you know you wattage limits and play around with ohms law

Sent from my LGLS740 using Tapatalk 2

Ok I'm using my wife's IPV mini usable up to 30 watts and a .5 coil... the battery is an 18650 panasonic (ncr18650pf) I believe it's a 10 amp battery

Quote:

---

Originally Posted by jclaiborne

Ok I'm using my wife's IPV mini usable up to 30 watts and a .5 coil... the battery is an 18650 panasonic (ncr18650pf) I believe it's a 10 amp battery

---

Should be ok. At 30w a .5 ohm coil will draw 7.7 amps

Sent from my LGLS740 using Tapatalk 2

On another note just got done patinaing a copper penny mod came out awesome
http://i60.tinypic.com/e5k8b4.jpg

Sent from my LGLS740 using Tapatalk 2

Ok I have yet another question...how accurate are these VV mods at reading resistance...when I meter out my coil with my multimeter it reads .9 every time I fire it on the mod the reading fluctuates from .9 to 2.9 and jumps all over. Should I just ignore what the mod reads out?

Usually if the resistance jumps like the its a loose connection to the coil. I used to have that problem till i switched all my rdas to grub nuts

Sent from my SPH-L720 using Tapatalk 2

I didn't read back, so I don't know what you have (and cause of that I give stupid suggestion)but some VW mods cannot manage the resistance under 1 ohm. If in your case you're sure cannot be that,( and I gave stupid suggestion..), just ignore me :rolleyes: