My Enclosure(So Far)

Ok so here are the pics of my enclosure I'm building.. it's not complete yet but he're's where I am so far.

Step 1
https://ball-pythons.net/gallery/fil.../6/6/encl1.jpg

Step 2
https://ball-pythons.net/gallery/fil.../6/6/encl2.jpg

Step 3
https://ball-pythons.net/gallery/fil.../6/6/encl3.jpg

Step 4
https://ball-pythons.net/gallery/fil.../6/6/encl4.jpg

https://ball-pythons.net/gallery/fil.../6/6/encl5.jpg
https://ball-pythons.net/gallery/fil.../6/6/encl6.jpg

Not too bad at all....:)

One thing I will share with you on it. You will want the front to open not the top. You cant stack them if they open on the top. ;)

I am eager to see the finished piece.

I will say, its easier to make top opening though.....

I only have the two BPs and unfortunately until I move(some time From now) I will not be getting any others that's why I did the top opening(and you're right it was easier lol). But I looked at yours and immediately thought about my stacking issue too.. yours works perfect for stacking! .. when I move I'll probably build a larger vertical Enclosure for multiple snakes.

any other Ideas for improvement at this point? anyone... anyone? lol sorry for the double post

Looking good man. Keep us updated.

So far, so good!

Looks good too. But what is the divider for? :oops:

was the wood pre cut for you? if not what did you use to cut it.

I Have 2 Bp's a male and a female so I devided the cage in 2 sections the larger for the female and the smaller for the male...

answer2: most of the wood was Pre cust

List of materials

1 4ft x 2ft x 8ft of 1/2 inch ply wood(had it precut into 3 pieces for top sides and bottom

3 2in x 3 in studs/beams cut into :

4 48 inch beams
8 24 inch beams

1 sheet of plexiglass 4ft x 2 ft 1/8 inch or thicker.

3 large hinges

1 box 2 inch drywall screws
1 box 1 5/8 inch drywall screws


Tip: put the bottom together first with the 2 48 inch beams on the bottom.

hope this helps

Looks good so far man... :gj: