Pepsi-incubator

Hi all, take a look at this Pepsi-incubator that I just made:
(photos are bad ones)

http://www.fororeptiles.org/galerias...badora_001.jpg
http://www.fororeptiles.org/galerias...badora_008.jpg
http://www.fororeptiles.org/galerias...badora_015.jpg
http://www.fororeptiles.org/galerias...badora_003.jpg
http://www.fororeptiles.org/galerias...badora_007.jpg
http://www.fororeptiles.org/galerias...badora_012.jpg
http://www.fororeptiles.org/galerias...badora_014.jpg

Looks good! Good luck with the eggs

Very nice!

Looks good! Does that one strip of flex keep the temps up?

Alan

I really like these, great job on yours.:gj:

I need one like that next year. Very nice

Quote:

---

Originally Posted by grunt_11b

Looks good! Does that one strip of flex keep the temps up?

Alan

---

Yes it does!, the spyder robotics thermostat is proportional and its screen shows the amount of energy that is suplying to the heat source. I've have set the incuabator at 90 degrees and it only went to 100% energy while establishing, but once set it generally goes to no more than 30%!!!. So that sigle strip of flex is more that enought but consider that temperature at the room is 82-84 F...

Where did you get the frig from?

Quote:

---

Originally Posted by dragondavy

Where did you get the frig from?

---

From a local swap meet it was a working one and It cost me $100, not really cheap but I dont have much time to search for a superdeal...

Thats cool, thanks again!!
:gj: