How?

How do you put you're holes in you're tubs?

I use a soldering iron. its less messy.
i've read that some people use a drill with a small bit.

be slow with a drill, it may crack the plastic

I use scissors, but I usually get alot of cuts and stuff...

a soldering iron works the best. if you want it to look clean use a peice of peg board as a templet. they will be evenly spaced and not look sloppy.

There are many ways to do. From using a soldering iron, to a drill, to a hole punch, or a blast from a shotgun with birdshot from 20 yards... Whichever suits your fancy!







WARNING
Provided you do not break any laws, put yourself or others at risk, or conduct any other forms of tom foolery.

sounds good to me. thanks all!

I've used either a drill or a soldering iron. Either works well, but that pegboard idea is fantastic! I'm going to try that on my next tubs. :)



hana