Ultratherm UTH Question

The Ultratherm heat pads I got from The Bean Farm have instructions that say you can cover them with 6mm (1/4") Polystyrene Board

For the purpose of directing the heat up thru the tank.

Lowes and Home Depot have no such stuff unless it's a $50.00 roll of the fanfold stuff 50' long.

I have a roll of Reflectix, (the foil bubble insulating stuff) I would think I could cover the heat pads with that. It should serve the same purpose shouldn't it??

As all heat pads are run with a thermostat, and they are on metal racks like this https://www.petco.com/shop/en/petcos...and-40-gallons so it is vented and not a solid surface, I don't forsee any over heating problems.

Any thoughts on this? Don't want to burn out a heat pad or crack a tank if I can avoid it.

Thanks for any input.

That worked very well for me on my AP cages.

The only thing was that extra thickness makes the cage sit lopsided and wobble. That’s why I added the cushions on the other 3 corners for leveling. Seen in last pic.

https://uploads.tapatalk-cdn.com/202...2644e89586.jpg

Ultratherm held down with foil tape. ^^

https://uploads.tapatalk-cdn.com/202...c816266d11.jpg

Add insulation bubbles vvv

https://uploads.tapatalk-cdn.com/202...d96dd8bad4.jpg

Good and sticky ^&

https://uploads.tapatalk-cdn.com/202...7940d2b08a.jpg

Add cushions ^^

Quote:

---

Originally Posted by Reinz

That worked very well for me on my AP cages.

The only thing was that extra thickness makes the cage sit lopsided and wobble. That’s why I added the cushions on the other 3 corners for leveling. Seen in last pic.

---

Thanks for the input....

Covered the whole bottom of the tanks, heat pad and all with reflectix. Temperatures didn't go up at all like I thought they would

They stayed stable, but the thermostat didn't cycle nearly as much as before. so that works much better.