Herpstat 2 question

So I bought a Herpstat 2 Redline. Set it up yesterday and it was running fine - temps were steady where I set them when I went to bed. It ran for probably 8 hours before I went to bed. I checked it once sometime over night, still good.

I had a Zoomed UTH set up on one output, an infrared bulb set up on another output. Both were set on dimming.

I got up this morning with the display reading “Error detected - 120v A.C. signal”.

I can’t find anything anywhere that tells me what this means. Anyone know?


Sent from my iPhone using Tapatalk

It means your sensor probe and 120 ac wire are too close together. Separate them.

edit: Sensor probe wire, not the sensor tip. ;)

Ok, how do I get the error message to reset? (I’m not at home right now, so if that’s a simple answer, forgive me).


Sent from my iPhone using Tapatalk

Sorry... I don't have time to look it up, but here's the manual: https://www.spyderrobotics.com/index...products_id=33

Quote:

---

Originally Posted by RickyNY

It means your sensor probe and 120 ac wire are too close together. Separate them.

edit: Sensor probe wire, not the sensor tip. ;)

---

Wow. Never thought of that. All mine run with the RHP wire and into a hole in the back of my AP’s. Guess ive always been lucky?


Sent from my iPhone using Tapatalk