Herpstat Probe Placement on a T8
Should have my BEL delivered in about an hour or so (hopefully), so just doing last minute tweaks in the enclosure.
T8, split in half. Right side has the Mexican Black Kingsnake, left side will have my incoming ball. Obviously, each half is 24"x24".
Opinions on probe placement, if its good there?
The RHP is more towards the front right. I placed the probe in the rear left, about 2.5" off the floor. See pics.
The herpstat is set to 80 degrees... and, right now, after running all night, left cool side says 80 and right side says 87. Humidity after some spraying shows 69% (was higher, but going down now).
All comments and opinions welcomed...
https://ball-pythons.net/forums/cach.../h1eUt6/01.jpg
https://ball-pythons.net/forums/cach.../mZjjRR/02.jpg
https://ball-pythons.net/forums/cach.../n2HhD6/03.jpg
https://ball-pythons.net/forums/cach.../m4U7fm/04.jpg
Re: Herpstat Probe Placement on a T8
Quote:
Originally Posted by
Charles8088
Opinions on probe placement, if its good there?
The RHP is more towards the front right. I placed the probe in the rear left, about 2.5" off the floor. See pics.
YES!
That's where I've had mine set for six years without problem. (Also running a T8 with an rhp) Given the size of your animal though, I usually aim to have the tip of the probe just slightly above where the top of the BP would be.
Your new buddy should be set. You may want to save yourself paper towel in the future though and pick up some indented Kraft paper however (found on Amazon or Uline). You get a HUGE roll of it that will last you a long time for not much money (at least compared to paper towel prices nowdays).
Re: Herpstat Probe Placement on a T8
Quote:
Originally Posted by
SDA
Side note. Get rid of that skull. recent post on the snake subreddit showed exactly what can happen due to those skulls.
Certainly don't want that to happen to this girl. Is that from sharp edges maybe?
Sent from my SM-N950U using Tapatalk
Re: Herpstat Probe Placement on a T8
Quote:
Originally Posted by
KevinK
Your new buddy should be set. You may want to save yourself paper towel in the future though and pick up some indented Kraft paper however (found on Amazon or Uline). You get a HUGE roll of it that will last you a long time for not much money (at least compared to paper towel prices nowdays).
Good to know, thanks. I will look into that, and probably pick up a roll. Ultimately I want to use Reptichip, which I have a ton of, but initially want the paper. But, good to have it all on-hand.
Re: Herpstat Probe Placement on a T8
Looks nice! Post pic lol :D
Re: Herpstat Probe Placement on a T8
Personally, I'd place the probe as low as possible so you have an accurate reading/temp where your BP actually is. Since your probe is higher, the temp on the floor might be higher than you want it to be.
Sent from my SM-G950U using Tapatalk