New Ball Python

Hi i am getting a new baby ball python tomorrow. it comes with a 20gal long a heat light bedding water dish hide and him for only 80 bucks plus a lid.and maybe the ball python manual. i dont no if its a male or female but i will have it probed.he eats live pinkie or fuzzie rats. i want to try him on f/t right away is that ok? or should i do one live then try f/t or what?

Personally, I would buy one f/t rodent and one live rodent for the first feeding. Thaw the frozen rodent and offer it to the bp first....if the bp takes the f/t, kill the live rodent and put it in the freezer for the next week. If it does not take the f/t rodent, attempt the live feeding. This would be a good way to go the first couple of weeks just to get the bp established in your care. If it never takes the f/t, get it eating consistantly on live....then try all the 'tricks' to get it switched over to f/t. You can search this forum...there is alot of info here.

ok thanks. i am going to bed now i cant wait to see my new bp. can you all think of some names for it?than can be for both sexes until i get it probed.

Congratulations! You will also need to get an under tank heater and another hide (one for the cool side and one for the warm side). We can't wait to hear all about him/her!

congrats on the new baby. if u havnt already, check out the care sheet in the care sheet section of this site. great info in there and we can help u with the rest. dont worry about asking tomany questions.

i already had a ball python in the past. i do already have an undertank heater for the new cage. can you all think of some names.

right now i am checking the temps of the heat pad he or she will use. should i also use the light. if i cover 2/3 of the lid with tinfoil then with like plastic rap or something to reflect the heat back down and to help with the humidity. do you think that will work?

I am not too sure what you trying to accomplish here. Are you trying to raise or lower the humidity ? Covering the lid will ofcourse help to increase humidity but using light will tend to burn out any moist within the cage.

i am trying to increase humidity and the ambient air temps. it most likely will have low humidity and low ambient air temps because its a screen lid.

I'm also a little confused because on another thread you talked about getting two balls and setting them up in racks, but now you're using an aquarium instead and just one snake?