T8 RHP cord routing

Is there some trick that I'm missing to get the cords from the rhp to lay nicely in the track that AP cuts?

Most of ours set right in with a bit of pressure, but a couple were tough and we had to carefully push the cord into the track with a flat head screwdriver.

Sent from my SM-G930V using Tapatalk

Is the cord from the rhp to the hole inside tight or did you leave some slack there?

sometimes the channel is tapered wider at the bottom so the top closes in over the wire to keep it in place. put the wire in at an angle so it fits in the wider bottom section then push the other half of the wire into the groove. hope that paints a picture for ya....Kirk

Got em! Started with it twisted and started from the exit of the hole helped. I was working from the back towards the center. Use the twist to advantage in the cord helped.

Glad you got it! Gotta love AP, they plan for everything. We had one that was cut funny that never slipped completely into place, but other than that, they're all perfect!

Sent from my SM-G930V using Tapatalk