need rack help

So i just got a new rack that was supposed to hold 1 v35s tub and 1 v18 tub. Well the shelf was too short so it will hold the v18 tubs but not the v35s tub unless it is sideways. i was wondering is there a way i can either cover the v35s tub so i can use the rack as i would like or can i add some xpvc to the shelves. i really needed a dual tub rack and cant afford to buy a whole new rack. Thank you

Where did you get the rack? Can't you take it up with them if it was supposed to be made to fit how you wanted?

So they sent you a product that didn't match description? Or were they supposed to hold the v35 sideways? Some racks hold long tub sideways but small tubs lengthwise.

If former, complain and get your money back. If the latter then set the heat tape on the side on the levels with the v35s.

It has been taken up with them but I got it on special for cheap. I was just wondering what I could do to cover the inch gap. I was thinking about glueing some screen to the tub

Sent from my VS985 4G using Tapatalk

Doesn't matter if it is on special or cheap. It is still a product produced by a company, and standards must be met. I would demand the correct product or be issued a refund and find something else. Don't accept an inferior product.