Removing flexwatt clips/changing wiring

I have my rack running flexwatt that was wired together for me using the clips.

I'm expanding the rack, and need to join more strips to my existing chain of strips.

Is it possible to get the wire out of the clip to wire the new strips into the chain? Or do I have to cut the clips away and completely rewire the last strip of my existing chain in order to expand it?

Thanks.

What you can do is clip the wires and splice them in with the new wires. There's these plastic caps you put on the ends to insulate, as well as using electrical tape. You have to make sure you keep them wired in series. I did this when I had to change my rack height to allow for a taller tank. Use the same wire if possible.

I think that taking the clips off of the tape might ruin either the clips or the tape.

I wouldn't take the clips off the tape, I had to cut a small piece off when I did that, which was no big deal for me as I was soldering the connections anyway. And you are wiring in parallel, not series. Is there a particular reason for not just adding another cord? Otherwise just splice into the existing wires to make the connection.

Right, that makes sense and would be about as easy as I was hoping it would be.

I will be using a different chord for the new strips, was just concerned with how difficult it would be to connect to the old chord.

I'm still a bit on the learning curve when it comes to working with wires (I can solder, though).

Quote:

---

Originally Posted by Drift

I'm still a bit on the learning curve when it comes to working with wires (I can solder, though).

---

If you can solder, then forget the clips imo. Personally I like using liquid electrical tape to insulate. also you could just solder onto the old tape and you're done.

Actually, unless you are very good with soldering, stay with the clips. I agree it gives a more solid and safe connection, especially when insulated with the liquid tape(I do this too) but it is VERY easy to overheat the heat tape in the process and have the conducting strip lift or even melt the plastic.