Heat problems

Right peeps. Got my mat stat set up on thishttp://img.tapatalk.com/d/14/03/07/e5yrube4.jpg
But my temp gauge is showin this
http://img.tapatalk.com/d/14/03/07/tyvajy8a.jpg

I'm new to BP ownership so just wanna make sure I'm doing everything right.

Cheers

Where is your thermostat sensor located? Are you using the habistat to control your heat mat?

Sent from my SAMSUNG-SGH-I747 using Tapatalk

Yes I'm using if to control my mata

With my UTHs I put my Tstat probe right on the heat mat (so on the outside taped to the heater) and keep adjusting the temp until I can get a temp gun temp of around 88-90 on the surface where the snake sits, not the mat itself. So the mat is going to be heated higher than what the actual snake will sit on in order to get the right temp.

Ok wen using an infared thermometer do I test through glass or in the viv???

As was previously mentioned, which I think you missed (so try to read carefully next time :P), you'll want to test at the hottest possible spot where the snake can get. So in the middle of the UTH, inside the vive - so on the very bottom of the vive, where the UTH is located outside the vive.