My incubator

Just got done with my incubator. Just need to figure out how to do the fans. Any ideas? http://img.tapatalk.com/d/12/11/14/nedyrugu.jpghttp://img.tapatalk.com/d/12/11/14/4u6e5u8a.jpg

Sent from my XT907 using Tapatalk 2

I do not think you have enough heat tape in there. It should go all the way up the back wall. And you do not want to have any of the egg boxes sitting directly on the heat tape so you'll need to fashion some type of shelf extension on that hump.

The fan should be on the ceiling just in front of the heat tape and blowing down. Don't skimp by using an old computer fan. Spend the money for a new 12v DC fan from Radio Shack. You don't want the fan to fail after the eggs are in.

I plugged it in and the inside temp got up to 110F. That's the last of the 11" flexwatt I have.

Sent from my XT907 using Tapatalk 2

That could be enough heat tape.

You might have more even temperatures from top to bottom if you move the flewatt up to the flat wall in the back and place a fan blowing air along its length.

What thermostat do you plan on using?

Only problems are the back wall isn't flat and if I do it from top to bottom the heat tape will cover the hole that the cords are coming through.

Sent from my XT907 using Tapatalk 2

You have to test it with the fan and with water bottles and egg boxes inside. The bottom boxes may get hotter than the top. You want it to be pretty even. Within one or two degrees.

I don't have a DC fan yet or any vermiculite so I cant do a full test.

Sent from my XT907 using Tapatalk 2

will these work? will the fan be to small?
http://www.radioshack.com/product/in...ductId=4218516
http://www.amazon.com/120mm-Quiet-Co.../dp/B0055MR6QO
i like this fan better.
http://www.amazon.com/Cooler-Master-...eywords=dc+fan

im going to be using one of the probes in my herpstat pro

Its hooked up to my herpstat pro and its staying at 89f even without my fan I got today.

Sent from my XT907 using Tapatalk 2