12qt rack just finished, cost me 10$!!

Just finished a 12qt rack. I had some leftover melamine pieces from some bedroom shelves I picked up when my aunt sold her house. These were the top and bottom pieces from the shelves. I had 12' of 4" flexwatt laying around. I had to go pick up the pre cut legs at lowes this morning while I was out. They ran me about 10$. It will house some 12qts for my hatchlings that are getting tight in their 6qts. I may try and find a tub that fills it out a little more.
http://img.tapatalk.com/d/12/11/05/jesypa6y.jpg
http://img.tapatalk.com/d/12/11/05/edehy7ut.jpg
http://img.tapatalk.com/d/12/11/05/paharapu.jpg
http://img.tapatalk.com/d/12/11/05/e5etu5yj.jpg
This will be in my 82 degree snake room, an open design won't be a problem.

That heat tape should be on the end of the tub, not in the middle, otherwise it looks like it will work fine :gj:

nice!
:gj:

Quote:

---

Originally Posted by snakesRkewl

That heat tape should be on the end of the tub, not in the middle, otherwise it looks like it will work fine :gj:

---

The tubs are much smaller than the shelves. I am going to try to find tubs that fill them out better. The heat tape is under the back of the 12qt, with the front lip an inch in on the front.