CHE and PVC

Can I hover a CHE over a PVC cage to help with temps? I read on a different thread to do that with a tub and wondering if it would help in my new PVC cages, right now, after buying 2 new cages, I can't afford 2 RHP.


Sent from my iPad using Tapatalk

Why? Shouldn't belly heat be enough?

At night the cage drops to below 78. The hot side is not getting above 82, I am worried about winter.


Sent from my iPad using Tapatalk

I have to use my RHPs and belly heat in the winter. I don't know about using CHEs with PVC though.

Ambient of 78* isn't bad. I keep my ambient at 75º Usually around 75-77.

If you are using belly heat, you should easily get a hot spot of 90º. What kind of thermometer is measuring your hot spot?

Just ordered a temp gun.


Sent from my iPad using Tapatalk

Your hot side is not getting over 82ºF ? The question I have is what kind of pad are you using. There are HUGE differences between brands and wattages some are designed not to get overly hot and may not be able to cope with a PVC cage insulation value and a cool room.

A RHP (RADIANT HEAT... Where the idea that a radiant heat source is actually a Convection heat source is baffling to me) does not change air temps in my experience with two (one test set up for 5 months) the best air temp change I managed was 4º. They (RHPs) replace UTH not ambient air heating methods. Personally I find a standard fluorescent tube mounted inside the enclosure lifts the ambient air temps exceptionally well. It is safe as its maxed temp (100ºF) is below a contact burn point and it is unlikely to lay against a light top mounted long enough to become unable to digest food. I find a 2 foot tube lifts 10º over the room temp. They are also about the cheapest convection heater around. (radiation aka RHP produce electromagnetic waves that transfer heat to objects, not air, just like the sun. Conduction transfers heat to objects in direct contact like a UTH or stove. Convection is a heat source that heat the air directly and causes thermal air currents like a wood stove or CHE.)

Temps ideally are Warm (hot) side surface 90ºF (88-94ºF)
cool side surface 80ºF (78-84ºF)
Ambient air temps 79-81ºF (75º-85ºF)

I quoted the temps that are closest to universally accepted the bracketed figures represent the extremes max and mins I have seen from reputable sources. It depends a bit on snake size too small snakes generate more heat while digesting than big snakes do so lower temp warm side temps are sometimes used (88ºF is common) with sub adult snakes.

The heat pad I use is from the link below. The cages do have a light strip that can be turned on during the day and off at night. Would that help?




http://www.reptilebasics.com/ultratherm-heat-pads


Sent from my iPad using Tapatalk

Ok here are pics of the enclosure.
From the front:
http://img.tapatalk.com/ae496fab-2420-621d.jpg

The floor space:
http://img.tapatalk.com/ae496fab-2438-b11e.jpg

The light at the top:
http://img.tapatalk.com/ae496fab-244f-420b.jpg
Is there a red bulb for this type of fixture?


The humidity box is not needed, but Buddy likes it during she'd time so I left it in there.

Sent from my iPad using Tapatalk

I have a PVC cage (Showcase Cages) and it actually has a spot for a CHE. So... I'd double check with the manufacturer, but I'd venture to guess they're fine.