Is this tub setup OK?

I did read Vyprz tub tutorial on how to setup a proper one, but just wanted to make sure it's not too small :) I saw that a lot of breeders and people who use tubs don't usually provide a cool side hide, and mine wouldn't fit, so I didn't put it in. But please let me know if you think I should switch out the water bowl for a smaller one and place a cool hide in! :)
The quality is terrible, my phone and my camera hate me :(

http://i1076.photobucket.com/albums/...logue1/006.jpg

Do you guys also think there are enough air holes? I soldered some holes into the front of the tub only:
http://i1076.photobucket.com/albums/...gue1/003-1.jpg

Looks good! I drill holes ALL the way around my tubs and even cut out the tops and place screens for even air flow.

16 quarts, by the way

Oh, ok Drama, thanks!

Looks fine to me. Maybe solder a few holes on the side?


If the humidity is too high, then you can switch out the water bowl to a smaller one or add more air holes.

Thank you satomi! I am soldering some more as soon as the iron warms up :)

What are you using to heat it?

I'm using a UTH on a thermostat. :)

Looks good. I put some holes in the lid as well for air flow.

Quote:

---

Originally Posted by Klogue1

I'm using a UTH on a thermostat. :)

---

Ok, looks good though I would make the substrate layer a little thinner.