Moisture like whoa

I have them in plastic storage container with a top that has holes in it and I'm noting A LOT of moisture build up, I'm using Aspen bedding.... How do I control this?

You need a lot more airflow. You need to cut out a big square hole on each side of the tub and cover it with quarter inch square metal screen.

When you say holes, do you mean you just poked holes in the plastic lid? If so, that is not near enough ventilation and you will get a lot of moisture buildup, and ammonia buildup. This can cause serious health problems for your rodents if left the way it is. I suggest cutting a large area of the lid out (ideally use the side of the tub) and put in some wire mesh (1/4-1/2")

Thanks guys I will do this as soon as I get home.... Any other beginner tips you want to send my way?

How would I secure the wire mesh to the plastic?

in this sticky. it shows you an option for securing the hardware cloth. appears to be cable ties. i would just make sure to check them every now and then to make sure they aren't being chewed on.

If you use thin wire you can tie the mesh on. (TIP!!!) use the thin wire that they have wrapped around the wire mesh to keep it rolled up ;)

http://i711.photobucket.com/albums/w...acks/006-1.jpg

If you cut out the top of the tub like these are then you won't have to worry about them chewing on plastic ties if you so choose to use those. I have feeder tubes going down into the tub from the middle of the mesh so they can climb on it so i used metal to tie everything. I have yet to have had a chew out!!

Once upon a time I used these, lol, they work, sort of :P
http://i32.photobucket.com/albums/d1...s/PICT0118.jpg

Quote:

---

Originally Posted by snakesRkewl

Once upon a time I used these, lol, they work, sort of :P
http://i32.photobucket.com/albums/d1...s/PICT0118.jpg

---

One big big mistake I see with what you did is that you have the wire mesh on the outside. They can chew the tub on the inside that way and chew right around the mesh and escape. Which is why you should put the mesh on the inside.

Utt oh :-X I used hot glue on the outside of the tub.. And 1/4" wire mesh anyone else use hot glue?