Hey,

I am planning on getting a new addition at the Daytona expo coming up in a few weeks. So, I am currently preparing for another snake by setting up her tub. But, of course, I ran into a problem. The ReptiTemp500r thermostat probe it too big to fit inbetween the tub and the UTH.

I can fit my finger under it without lifting it up.

This is how big the probe is.


So, if I try to put the probe in the middle of the UTH in between the tub and UTH, it will not fit without the UTH having to bend out in the middle.

Does anyone have any solutions?

Thanks,