AP Economy Plastics Rack Tubs

[the_Ryno]

They list the Sterlite Box 1756(32qt) as the tub for their Economy Plastics Rack line. But when you click the link at the bottom of the page, the Target.com page kindly informs you the page cant be found. After some further research I found out the 1756 is discontinued. What is the replacement for this tub? Or did AP make a new rack?

The dimensions of the tub are listed by AP as 23½x17x6.


Any help would be greatly appreciated.

[PythonBreeder]

The tubs were remade. They are at target again but now they have little clips on the side for a locking lid. I just broke mine off.

[the_Ryno]

Is it the same model # as before?

[XGetSome]

Is it the same model # as before?

Somebody correct me if i am wrong.

1755 replaced 1756, and they fit in the AP economy rack, but tighter fit. Where the handle(clips are)there will be a small gap if you break em off, this is ok for your avergae ball pythons, but smaller snakkes like colubrids could escape.

[SugarFox03]

Item 1752, 1754 and 1756 have been replaced with 1751 (6qt), 1753 (15qt) and 1755 (32 qt).

I have an AP rack that has some 1754 tubs (came with it) and I needed more and so purchased the 1753 tubs. They fit, but are a bit snug - they are a little harder to pull out/push in than the original 1754 tubs. I got them at Target for $3. I have no experience using the new 1755 tubs. I too just broke the purple handles off. It leaves a small gap, but I have some less then 1 month old ball babies in them and there's absolutely no way they can get out.

[ted1025]

Does anyone have the measurements for the 1755?