I have seen many articles on using flexwatt and how to connect it up both with the clips and soildering. I have also seen many articles about using it in the tank and under the tank, but I have not seen anything that discribes how you actually need to use it in the tank.

I am building a new 4x2 enclosure starting this weekend, and I am planning on using flexwatt in the enclosure. What are the precausions I need to take to make sure there are no injuries. Do I need to put some covering over it? I was going to make a reccess in the wood to hold the FW, using silicon around the entire underside of the FW to make sure nothing gets under it.

Just looking for a good how to with using it in the tank.

Thanks,
Chuck