I think this is in the right place.. D:
Move it if it is not please. ^_^

So I just set up the new bin recommended and updated HERE. I also posted pictures there of my new set up. :]

However, I bought a flexwatt and had it soldered for me. All good right? I plugged in my Ranco Thermostat and set it at Temp: F, 90, HI, and 1 (I don't know what the last setting was but it just had single digit numbers..)
I plugged in the flexwatt to the thermostat bar and clicked the switch to on.
The switch didn't light up like I expected it to.. and the flexwatt has been on for about an hour without heating up.

What am I doing wrong?