Help!

[pythongrl]

i recieved my boaphile 4 rack system..where do i put the probe???..im using a ranco thermostat...also f i use aspen how do u keep the humidity up if u cant mist it???..i use cypress now....thanks..im switiching from tanks so im not familiar w/ rack systems
thanks again

[cueball]

if i use aspen how do u keep the humidity up

I bet you will find that when using the rack setup you will not need any additional moisture for the aspen. The tubs(not having a vertical escape) hold the humidity very well. Good luck and enjoy the awesomeness that is the rack system

[pythongrl]

I bet you will find that when using the rack setup you will not need any additional moisture for the aspen. The tubs(not having a vertical escape) hold the humidity very well. Good luck and enjoy the awesomeness that is the rack system

cool..i figured out hom to use the probe..also do u bake u;re aspen?..i bake the the cypress..thanks again

[cueball]

cool..i figured out hom to use the probe..also do u bake u;re aspen?..i bake the the cypress..thanks again

If you buy the sealed compressed aspen I would not worry about baking it. That type of aspen is not likely to have problems.

[pythongrl]

should I drill air holes in the front of the bins??

[jotay]

Jeff at Boaphile recommends placing the probe thru the back in the hole that the flex cord comes out of and put it all the way over to the right or left so it won't interfer w/ sliding the drawer in and out. He said place the probe right in the corner where the flex bends 90 degress and secure it w/ clear plastic shipping tape. I spoke with him a few weeks ago as I ordered the 4 tub ball room rack from him.
He also said you very well may not need to drill holes. It's not required but he said if temps run to hot or humidity runs to high to drill or burn them in the sides not the front or back.
Hope this helps

[pythongrl]

Jeff at Boaphile recommends placing the probe thru the back in the hole that the flex cord comes out of and put it all the way over to the right or left so it won't interfer w/ sliding the drawer in and out. He said place the probe right in the corner where the flex bends 90 degress and secure it w/ clear plastic shipping tape. I spoke with him a few weeks ago as I ordered the 4 tub ball room rack from him.
He also said you very well may not need to drill holes. It's not required but he said if temps run to hot or humidity runs to high to drill or burn them in the sides not the front or back.
Hope this helps

thanks..I drilled another little hole in the middle tub so the thermostat can run using the middle tub b/c heat rises and taped to the side of the flexwatt using foil tape..i will keep and eye on the temps and humidity...thanks