I have a set of 3 T18's, They are going to be stacked.
On the bottom where the Flexwatt goes I have the cut-outs for the thermostat probe but the rest of the bottom is flush (all smooth)
The pictures I have seen show a cut-out for the Flexwatt mat to go into. Obviously with the connections on the heat mat and no cut out there is no way
to stack them and have them sit evenly. Do any of you recent recipients of an AP Enclosure find the same for your setup? or is this just something
that was just missed on mine? (I did order the belly heat option from them).
My thought was to mount the heat tape on the bottom with the connections flush with the back panel, but sticking out so I can stack them flush
Any other thoughts?
The connections on the heat mat look like the picture below
Reply With Quote