JumpStart help?

[DLena]

The JumpStart thermostat is blinking e2. I said I could go look at it and the total set up (there are some issues) tomorrow. I’ve “done the Google,” but don’t see any info on this.
Any ideas?

[55fingers]

It says on the hydrofarm website that it's an error code:

E2: tempature is too high, has exceeded the upper limit of the range.

[EL-Ziggy]

I got that error code once with a new unit. It was defective so I sent it back for a replacement.

[DLena]

Thank you very much. I’m getting over there tomorrow. Obviously something is very wrong. I had her turn everything off. I believe this unit is around a year old. I’ll figure out it it failed, or if she’s hit something else going on.