Hello, everyone. I'm currently in the process of getting everything ready for my first ball python, which is going to be a female that is currently 122 grams. I bought a 32 qt Sterlite tub to keep her in for now, but from what I've been reading, I think this might be too big for her right now. I also might have messed up with the ventilation holes. We don't own a drill, so at first I tried making holes with a knife until it got big enough to fit the tip of a pair of scissors in to enlarge it. That worked, but it took a long time to do one hole, and the end product would need a lot of sanding just to make it not so ragged, since I don't want to risk her hurting herself on the holes. I read something about using a hand held soldering iron, so I went to pick one up at Theisen's and was told that they aren't supposed to get hot enough to melt through plastic tubs, and was told to instead heat up a nail and use that to melt holes. I tried that, and it left burnt plastic all around the holes. I tried wiping it off, and it didn't come off at all. It also doesn't seem to have any sort of odor to it either, so I was wondering if I should go ahead and try to use sand paper to smooth all of the holes and get the black parts off, or if it would be best to get a new tub and start over. If so, what size tub should I get for a 122 gram bp?