Heya, all.

So...I'm spending WAY too much time surfing this site (and all the links to other BP-related sites that I find on here).

I have a 4-stack vivarium at my home, that I built myself. It's made from oak plywood and plexiglass. For each of the 4 vivariums, I have an intellitemp heat pad that sits underneath linoleum flooring. On top of the linoleum is the aspen or cypress substrate. Right now, I am running all 4 pads off of one thermostat, and use added substrate to get my temps where I want them in each tank.

I've recently found a good bit of info on the Herpstat 4, and it sounds like it was made specifically for me!!

I have two corns, and two BPs. Obviously, the corns need temps that are lower than what's needed for my pythons...so the idea of being able to manage each tank individually sounds awesome.

Here's my question(s):

1. Does anybody out there use one of these Herpstats in a similar set-up...and if so, is it working well for you?

2. Anybody know where the best place to buy one might be?

Any info would be appreciated.

KD