Help me with glass lid

[xperience]

Hi!!! I will make a glass lid for my ball python.Size of the lid -80cmX44cm.I need to know what ventilation to do? I will cut 2 holes in the glass-one on each end.Size of holes- 32cmX25cm and 32cmX10cm.. Is this enough or it is too big? I wonder-to make these two holes ot just to cut one bigger hole in the middle of lid??The holes will be covered with mesh.Thank you!!

[Apophis]

it would be easier to use plexiglass and lust drill your holes.

[cmack91]

actual glass? thats gonna be tough, but if you have the tools i would go one in the middle, its less risk to brake the glass, if its plexi-glass/acrylic take a look at this:
http://ball-pythons.net/forums/showt...arium-Solution

[xperience]

no plexiglass...I cannot glue the mesh to it.Are these two holes that I will make enough?

[xperience]

actual glass? thats gonna be tough, but if you have the tools i would go one in the middle, its less risk to brake the glass, if its plexi-glass/acrylic take a look at this:
http://ball-pythons.net/forums/showt...arium-Solution

Ok-if one in the middle-how big?

[xperience]

..

[cmack91]

im sure a 6x4" or 8x4" would be fine (15x10-20x10cm) or something around that size