Those three eggs look great! I would fit a covering of “ press and seal” over the tub. Make sure the top of the eggs aren’t in contact with the “press and seal” and place the tub lid back in place. Monitor the eggs on a daily basis visually for signs of abnormalities. There is a good possibility those slugs may detach spontaneously as the good eggs continue to develop. Personally, I would just monitor it going forward. Try to refrain from opening the tub once back in your incubator if at all possible.
Last edited by Albert Clark; 04-02-2022 at 09:09 AM.
I agree with Albert Clark's post above ^ ^ ^ and I think you don't need to worry about that bad egg- it's more likely to just harden up & cause no trouble as far as mold- it's always been this way. I also used plastic wrap as suggested when incubating eggs to keep in the humidity- just make sure you don't get condensation dripping from above on the eggs if it's too moist. (that too is fixable- just something to keep an eye on)
Rudeness is the weak man's imitation of strength. Eric Hoffer(1902 - 1983)
I came back with the results! So, I didn't have the courage to mess with the eggs, so I just left them be. The bad eggs went totally moulded and brown and attached, but did't became smelly and didn't affect the good ones. All the 3 egg hatched 61-62 days naturally (low temps-31 C), and the babies are fine!
Reply With Quote
Stay in peace and not pieces.
Congratulations! 
Good job!