» Site Navigation
2 members and 3,397 guests
Most users ever online was 6,337, 01-24-2020 at 04:30 AM.
» Today's Birthdays
» Stats
Members: 75,093
Threads: 248,535
Posts: 2,568,714
Top Poster: JLC (31,651)
|
-
Re: Anybody Identify This Pic??
Originally Posted by nikkubus
Glad they finally found your tub, what a pain. I'd go for the upper sides vs the lid personally for ventilation because you get nice crossflow, but evaporation holds in a bit better. I'll let someone with carpet experience answer the correct amount. The ribs shouldn't be a problem, a little air gap between the heat pad is fine.
I went around the tub and used a soldering iron to put a hole every 3 inches, I believe that should be enough. I can double that up if needed.
-
-
Re: Anybody Identify This Pic??
Originally Posted by bcr229
Ugh, 30 years ago I lived and worked in Reston. Thank you for the reminder that I made a good decision to move into WV!
The gaps under the tub should be fine, it'll just give you a place to put the thermostat probe.
I'll be looking for my forever home in about a year. West Virginia or Pennsylvania is where most of my family is from and the 2 states I'm looking at
So far West Virginia holds the lead, as far as how it's run, firearm laws ect it seem to be a better run state right now.
-
The Following User Says Thank You to Gocntry For This Useful Post:
-
Re: Anybody Identify This Pic??
and just to make sure.....
Heat mat set to give an 88* hot spot, just like the Ball Pythons?
-
-
Re: Anybody Identify This Pic??
Originally Posted by Gocntry
and just to make sure.....
Heat mat set to give an 88* hot spot, just like the Ball Pythons?
Yeah that's what mine is, assuming the ambient in the room is mid-upper 70's. If it's cooler you may want a second heat pad set to about 82*F.
-
The Following 2 Users Say Thank You to bcr229 For This Useful Post:
Gocntry (06-07-2021),jmcrook (06-06-2021)
-
Re: Anybody Identify This Pic??
Well trip is set for pickup, leaving at 8:30am tomorrow.
Barring anything drastic I'll be coming home with a new family member
Will start a new thread, and post pics when I can.
-
The Following 3 Users Say Thank You to Gocntry For This Useful Post:
bcr229 (06-07-2021),Erie_herps (06-07-2021),nikkubus (06-07-2021)
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|