» Site Navigation
1 members and 3,385 guests
Most users ever online was 6,337, 01-24-2020 at 04:30 AM.
» Today's Birthdays
» Stats
Members: 75,093
Threads: 248,535
Posts: 2,568,713
Top Poster: JLC (31,651)
|
-
At least you're open to learning and taking the steps to improve her setup.
Don't beat yourself up, we are all still learning, we've all made mistakes.
Don't be afraid to ask questions, we're happy to help.
-
The Following User Says Thank You to Craiga 01453 For This Useful Post:
-
Registered User
Re: BP not eating
Ok, I need help. I got the the temp controllers, but what is the best way to set this up? On the cool side I have the heat emitter suspended above the tank, and on the hot side I have a day lamp and a night lamp suspended above the tank and set to switch every 12 hours or so depending what season it is (I change timers according to when days get shorter in the winter). I also raised both lamps so that its 80 on the cool side and 90 on the hot side. Do I need temp controllers for all 3 heat sources? If so I may have got the wrong ones. What would you recommend for a thermostat?
Sent from my SM-S767VL using Tapatalk
-
-
Registered User
Re: BP not eating
Or should I just re do my whole heat set up, is there a better way?
Sent from my SM-S767VL using Tapatalk
-
-
Registered User
Re: BP not eating
Im not sure what room temps you are working with, but if it isnt too cold, you could simply run your under tank heat pad with thermostat, set to 88 or so, and a ceramic heat emitter over the top with a thermostat set to 80 to keep ambient temps stable. That is what I do. BPs are nocturnal, so as long as they get some kind of day/night cycle (which any room with a window will provide), they are fine.
Sent from my LM-X220 using Tapatalk
-
The Following User Says Thank You to Turningstar For This Useful Post:
-
Husbandry aside. Like it's been said before, downsizing prey is a good way to kickstart them into eating. I also like to pre-scent the enclosure. After I euthanize the rat, I'll use the low cool setting on my blow dryer to gently blow rat scent into the enclosure. That usually gets them twitchy and excited to feed. Then I warm it up a bit and present it to the snake. I also try to make sure the enclosure is clean with fresh substrate when I do this if it's a picky eater.
-
The Following User Says Thank You to cletus For This Useful Post:
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|