The setup is finally ready!

[Red357]

Can you plug the mat in without the Thermostat and take a reading to see how hot it gets? This is to just rule out the mat can produce the temps you need.

I have done that. I get different readings. The laser gun gives me from 86 up to 103. The snake stays on the cooler side. It kinda freaks me out and I reconnect the thermostat. Maybe I should place the probe closer to where I get a reading of 103 and tone the thermostat down from there?

Sent from my SM-N950U using Tapatalk

[SquirmyPug]

Almost sounds like you're just getting bad readings because of the glass. Try putting a piece of paper or something right on top of the glass and check the temp on that