Thoughts?

[Ax01]

but hey u could always sell your car to buy some PVC cages. oh wait...

Hahahahaha, ssssshhhhhh

ok!

I've used similar shelving I purchased at Home Depot without issues for years. Just cut the legs down to fit better over the tubs.

i think Cwaig was gonna convert them into display enclosures - using the shelves as the frame w/ plywood woods. butt yes, those are like the racks i was referring to. they look great.

[Craiga 01453]

I'm going to agree with others in this thread and also give you the advice of saving up your money and just getting the right product. You and your snakes will be much happier in the long run, and my experience has always been that I became dissatisfied with home made enclosures and eventually spent the money on good quality professional enclosures, thereby spending much more over time.

I have a room full of vision enclosures, which I really like. A friend of mine has a room full of AP cages, and they are fantastic enclosures with a price point advantage, so for your situation I would take a hard look at them.

I also make a very meager living, but I've found that by abstaining from other potential drains on my resources I have always been able to tuck away enough money to provide my animals with a standard of living that is arguably better than my own.

Good luck!

Thanks!! I've decided to consolidate enclosures, upgrade heating equipment and save my money for APs down the road.

I've used similar shelving I purchased at Home Depot without issues for years. Just cut the legs down to fit better over the tubs.

Sent from my moto g(6) play using Tapatalk

That's exactly the route I've decided to go!! Your setup looks great!

ok!


i think Cwaig was gonna convert them into display enclosures - using the shelves as the frame w/ plywood woods. butt yes, those are like the racks i was referring to. they look great.

Yeah, after digging a bit deeper I've decided to use the shelves for tubs. Upgrade heating equipment and save my money for APs down the road

[PghBall]

I too one day want to get myself either Vision or Freedom Breeder racks. But right now they are just not in my budget. I can let you know that the rack I put together above does not sag, has stood up to the heating without issue (I set my Tstat to 98 degrees and have 4 inch heat tape cut to 3 foot sections on each level). My snakes all are doing quite well in my "cheap" setup .